Torture Test Error - Page 4

2006-10-13, 21:09

Bugger - as before, I get the following:

RGB1
Signal Error
H 64KHZ P: V 60HZ P

:(

paulunderwood · 2006-10-13, 21:13

This should not happen... It sounds like a "standard vga" error. I would suggest a windows repair like the one I linked above...

Anyway, instead, why not boot Windoze normally and, now that you have BIOS set to "failsafe", try to run prime95 for a while and see if you still get errors...

HTH

2006-10-13, 21:23

Ok Paul - thanks for all your advice so far.

I'll post back tomorrow if it goes to plan - if not then I guess I'll be here before I know it!

I've just started the Torture Test and Task Manager reports that it is using 50% of the CPU and 1,475,536K of RAM, which is about 3/4 of my 2GB. (4 x 512MB) This sounds normal in a stress test - correct?

paulunderwood · 2006-10-13, 21:26

I don't know much about prime95, but the blend test will stress your system the most, showing up any weaknesses...

50% because your computer is HT-enabled -- really like 100%. This is normal and you do not need to change anything.

2006-10-13, 21:13	#35
paulunderwood Sep 2002 Database er0rr 3,761 Posts	This should not happen... It sounds like a "standard vga" error. I would suggest a windows repair like the one I linked above... Anyway, instead, why not boot Windoze normally and, now that you have BIOS set to "failsafe", try to run prime95 for a while and see if you still get errors... HTH Last fiddled with by paulunderwood on 2006-10-13 at 21:15

2006-10-13, 21:26	#37
paulunderwood Sep 2002 Database er0rr 3,761 Posts	I don't know much about prime95, but the blend test will stress your system the most, showing up any weaknesses... 50% because your computer is HT-enabled -- really like 100%. This is normal and you do not need to change anything. Last fiddled with by paulunderwood on 2006-10-13 at 21:27

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Icon red but no error on torture test	justintime	Hardware	2	2011-07-02 17:41
Error message during torture test	esqrkim	Hardware	9	2010-03-21 15:28
Yet another Torture Test Fatal Error	Unregistered	Information & Answers	9	2008-12-10 04:17
fatal error in torture test	Unregistered	Hardware	3	2006-12-18 15:30
Torture Test error	Unregistered	Hardware	27	2005-12-29 15:37

2006-10-13, 21:09	#34
krypton_ls 2·3,539 Posts	Bugger - as before, I get the following: RGB1 Signal Error H 64KHZ P: V 60HZ P :(

2006-10-13, 21:23	#36
krypton_ls 7824₁₀ Posts	Ok Paul - thanks for all your advice so far. I'll post back tomorrow if it goes to plan - if not then I guess I'll be here before I know it! I've just started the Torture Test and Task Manager reports that it is using 50% of the CPU and 1,475,536K of RAM, which is about 3/4 of my 2GB. (4 x 512MB) This sounds normal in a stress test - correct?