20180112, 15:25  #1 
"Vasiliy"
Apr 2017
Ukraine
2^{2}·3·5 Posts 
My luck
I didn't find 12digit factor after 1000 curves with B1=11000
What are the odds? Last fiddled with by vasyannyasha on 20180112 at 15:25 Reason: too many zeros 
20180112, 17:10  #2 
Apr 2010
Over the rainbow
2,417 Posts 
what number did you test?

20180112, 17:18  #3 
"Vasiliy"
Apr 2017
Ukraine
74_{8} Posts 
111digit number from aliquot sequence

20180112, 17:20  #4 
"Vasiliy"
Apr 2017
Ukraine
111100_{2} Posts 
GMPECM write only about odds for 35digit factor and bigger.

20180112, 17:38  #5 
"Victor de Hollander"
Aug 2011
the Netherlands
2230_{8} Posts 
Assuming you're testing a number in a normal range (100400 digits)
With GMPECM t20 = 86 curves with B1=11,000 B2=1,873,422 1000 curves = more than 11 x t20 So after 1000 curves you should've found a 20 digit factor 11 times on average. Chance to miss a 20 digit factor after 1000 curves is very small e^(11) = ~ 0.0000167 = 0.00167% Are you sure your software has compiled ok? Is the memory ok? Willing to share the number in question? So we can run a couple of hundred curves to check if GMPECM finds the factor on different hardware? Last fiddled with by VictordeHolland on 20180112 at 17:50 Reason: number? 
20180112, 17:52  #6 
"Vasiliy"
Apr 2017
Ukraine
2^{2}×3×5 Posts 
Before this I find dozens of different factors with ECM.
Memory work fine. Maybe this was bug for 30 seconds. After this P1 test used 2 GB and find this factor. Last fiddled with by vasyannyasha on 20180112 at 18:02 Reason: My English 
20180113, 17:51  #7  
Mar 2006
2^{3}×59 Posts 
Quote:
I think the differences in our numbers stems from GMPECM v7 recommending 106.7632 curves to find a 20digit factor with B1=11e3 with param=1. I think you might be using param=0. You can read more about my web page to calculate ecm success/failure chances here: http://www.mersenneforum.org/showthread.php?t=22924 Last fiddled with by WraithX on 20180113 at 17:53 

20180113, 18:28  #8  
"Serge"
Mar 2008
Phi(4,2^7658614+1)/2
2·3^{3}·13^{2} Posts 
Quote:
If your darts do not hit the dart board, the odds are that there could be a problem with darts, or with the dart board, or with the air between the darts and the darts board, or with the thrower of darts. (In no particular order.) 

Thread Tools  
Similar Threads  
Thread  Thread Starter  Forum  Replies  Last Post 
Planet closing in causing my family's bad luck ?  science_man_88  Astronomy  16  20100921 03:44 