|
2020-05-10, 15:10
|
#1 |
|
May 2020
22 Posts |
Manual ECM request missing cofactors
When requesting work type "ECM on Mersenne cofactors", either manually or via Primenet, the entry in worktodo.txt includes the existing cofactor(s) [0], e.g.
ECM2=____,1,2,274199,-1,250000,25000000,150,"548399,3269797932048497" The Primenet assignment details page does not include the cofactors, e.g. ECM2=____,1,2,274199,-1,250000,25000000,150 The issue is that, as documented in undoc.txt, by default ECM will stop when a new factor is found. The known cofactor is then reported as a new factor. Is there a reason not to provide cofactors on the assignment details page? [0] https://www.mersenne.ca/exponent/274199 [1] https://www.mersenne.org/workload/ |
|
|
|
2020-08-22, 21:14
|
#2 |
|
Aug 2020
2×3×19 Posts |
Just want to bring this issue to attention since it hasn't gone yet. The entries produced on https://www.mersenne.org/manual_assignment/ are fine but those on https://www.mersenne.org/workload/ are missing the known factors.
|
|
|
|
 |
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fermat cofactors | yorix | FermatSearch | 14 | 2022-05-14 21:26 |
| manual result submission page feature request | kriesel | PrimeNet | 15 | 2021-09-06 15:44 |
| Manual Assignment Feature Request | xx005fs | PrimeNet | 12 | 2020-01-21 09:16 |
| Manual Testing ECM on cofactors? | yih117 | PrimeNet | 24 | 2018-02-03 15:46 |
| GIMPS PrimeNet Manual Exponent request Error code: 40 | GhettoChild | PrimeNet | 31 | 2016-01-27 17:25 |
