Incorrect hyperthreading detected

ktundu · 2017-06-30, 09:37

Apologies if this has been asked before, I couldn't find it if it has.

I've just started running prime95 on one of my linux workstations. It's a dual-socket system with a pair of quad-core xeons in it. However, when I run it, it thinks that the system only has 4 physical cores rather than the 8 it really has. This means than when it's running, it only uses half of my physical cores. Is there any way to change this so it uses all the cores in my system?

kladner · 2017-06-30, 15:23

I am not sure how multi-socket cores get counted. However, if you are using =>V29.1, the following is an example, with lines commented out, in local.txt, sets affinity. This is for a single quad CPU with hyperthreading on, running a single worker with 4 physical cores.

[Worker #1]
Affinity=1,3,5,7
# Affinity=0,2,4,6

# [Worker #2]
# Affinity=3,5,7

Prime95 · 2017-06-30, 15:24

Try version 29.1 or 29.2

ktundu · 2017-07-05, 15:53

Thanks, that seems to have got it using all my cores properly.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Are P-1 errors detected?	petrw1	PrimeNet	17	2018-07-04 20:13
What problems are detected	MrAskew	Information & Answers	1	2010-09-24 13:48
Wrong CPU Speed detected w/25.8	TheOutcaste	Information & Answers	7	2009-01-04 03:29
Hardware failure detected !!!	MaZeNsMz	Information & Answers	2	2008-06-21 12:05
Hardware Failure Detected	bigal_nz	Hardware	2	2007-02-07 10:43

2017-06-30, 09:37	#1
ktundu Jun 2017 2 Posts	Incorrect hyperthreading detected Apologies if this has been asked before, I couldn't find it if it has. I've just started running prime95 on one of my linux workstations. It's a dual-socket system with a pair of quad-core xeons in it. However, when I run it, it thinks that the system only has 4 physical cores rather than the 8 it really has. This means than when it's running, it only uses half of my physical cores. Is there any way to change this so it uses all the cores in my system?

2017-06-30, 15:23	#2
kladner "Kieren" Jul 2011 In My Own Galaxy! 2·3·1,693 Posts	I am not sure how multi-socket cores get counted. However, if you are using =>V29.1, the following is an example, with lines commented out, in local.txt, sets affinity. This is for a single quad CPU with hyperthreading on, running a single worker with 4 physical cores. [Worker #1] Affinity=1,3,5,7 # Affinity=0,2,4,6 # [Worker #2] # Affinity=3,5,7

2017-06-30, 15:24	#3
Prime95 P90 years forever! Aug 2002 Yeehaw, FL 5·11·137 Posts	Try version 29.1 or 29.2

2017-07-05, 15:53	#4
ktundu Jun 2017 2 Posts	Thanks, that seems to have got it using all my cores properly.