mersenneforum.org - View Single Post - command line switch for the number of workers to start

roemer2201 · 2012-02-15, 08:49

Dear All,

usually I run mprime on one cluster node, which has 12 Cores, so my mprime-setup has 12 workers. Is there a possibility to run mprime with a certain amount of worker threads from the command line? E.g. "./mprime -d --workers 4"?

Thank You

2012-02-15, 08:49	#1
roemer2201 Dec 2008 127.0.0.1 2·7 Posts	command line switch for the number of workers to start Dear All, usually I run mprime on one cluster node, which has 12 Cores, so my mprime-setup has 12 workers. Is there a possibility to run mprime with a certain amount of worker threads from the command line? E.g. "./mprime -d --workers 4"? Thank You