View Single Post
Old 2009-05-04, 08:01   #40
gd_barnes's Avatar
May 2007
Kansas; USA

26×3×53 Posts

To be more specific: To start it, go to the command prompt and type:

./LLR -m

It will allow you to enter the same info. that you would from Window's LLR.

To run sr2sieve in Linux, all the commands are identical except that you'd put the ./ before everything on the command line, i.e.:

./sr2sieve -P xxex -i xxxx.txt (etc.)

Last fiddled with by gd_barnes on 2009-05-04 at 08:02
gd_barnes is offline   Reply With Quote