View Single Post
Old 2015-03-22, 18:52   #3
TheMawn
 
TheMawn's Avatar
 
May 2013
East. Always East.

110101111112 Posts
Default

Make sure to read Dubslow's non-spoiler text first and give it some thought. Then read his spoiler text and think about it some more.

If you don't have it after a good few minutes of thinking, read my spoiler text. It will benefit you to try to figure it out yourself.


f(x,y,z) = 0 is probably a re-jiggered equation z = f[SUB]1[/SUB](x,y). For example, the elevation z of the ground at co-ordinates (x,y). The partial derivative dz/dx is asking you how much z changes when you change x (how steep is the climb / descent when you move along the x direction). This will entirely depend on what your "starting point" is so the answer will depend on both x and y.

In this case, how does y change when you move in the x direction (or vice versa, for that matter)? It doesn't. Your y coordinate stays the same if you're only moving in x. That's why that partial derivative is zero. This explanation is an example which applies to any two variables that are independent of each other.

Note this is an interesting situation where dy/dx = 0 and dx/dy = 0. In a lot of cases you can more or less safely play with dy and dx like they are just normal values (chain rule: dz/dx = dz/dy * dy/dx; what if you "cancel" the dy's?) but in this case you can't: with dy/dx = 0 it's a trap to then assume dx/dy is undefined (i.e. division by 0).

Last fiddled with by TheMawn on 2015-03-22 at 18:53
TheMawn is offline   Reply With Quote