Thread: k=13236795
View Single Post
Old 2021-12-03, 01:51   #102
VBCurtis
 
VBCurtis's Avatar
 
"Curtis"
Feb 2005
Riverside, CA

2·5·232 Posts
Default

If you're going to LLR test the entire file, then one should sieve until the factor-removal rate is half as fast (twice the seconds per factor) as an LLR test takes for the smallest candidate in the file.

This is due to the way the sieve scales- when you take candidates out of the sieve for LLR, the sieve speed does not change linearly. Since there is not much speed to be gained by taking candidates out, we leave the small candidates in longer than common-sense might suggest.

A rough scaling example: If you take out 10% of the candidates from the sieve file, the sieve only runs ~5% faster ("faster" as measured by p/sec).
VBCurtis is offline   Reply With Quote