View Single Post
Old 2009-08-03, 14:28   #9
mdettweiler
A Sunny Moo
 
mdettweiler's Avatar
 
Aug 2007
USA (GMT-5)

11000011010012 Posts
Default

Quote:
Originally Posted by gd_barnes View Post
Hum. That's very possible but we do need to double-check all of them. I'll have to investigate and get back with you late this afternoon.

In the mean time, can you check the file that is in G2000 to make sure none of those k's are there? If none are there, the web page interfaces appear to be completely correct for this particular testing and we can start G5000 at any time.
I've checked and it looks like all four of those k's were omitted from the file for n<500K. (Since the range we're doing right now in the server is 300K-350K, the k's don't have any incidence at all in the server.)

Per this thread, this is correct for the 3rd Drive. Nonetheless, yes, those k's should be doublechecked. However, we do have one problem: since we didn't originally test them the first time around, we don't have first-pass residuals for those k's. But, we really need to have two sets of residuals for each k/n pair in order to make a proper doublecheck. So here's what I'm proposing: we quickly re-do those k's to get "first-pass" residuals, then we add them to G2000 to be included in the doublecheck. We'll then end up with two residuals for each k/n pair, as needed.

Quote:
Once G5000 starts handing out pairs, can you do a quick spot check to make sure there are a full 195 k's listed on the appropriate web page interface? The file that I sent you should have all k's in there for k=3010-3400.

BTW, I goofed in two ways on the range for G5000. We're only testing k=3010-3400, not 3000-3400 since Lennart has done 3000-3010. Also, we're only doing n=50K-400K not 50K-425K. We're stopping at 400K because that is where the mini-drive started. When people reserve individual k's on the k=3200-3400 range, they'll just need to do a little non-top-5000 work, which would also be the case if we loaded n=50K-425K so we may as well be consistent with k=3010-3200. I've corrected that (once again) in the 1st post. Sheesh. lol

Just a friendly reminder to be sure and only initially load n=50K-75K and in k-value sequence. Thanks.
Okay, sounds good. I'll get the sieve file prepped and loaded as soon as possible, hopefully today.
mdettweiler is offline   Reply With Quote