View Single Post
Old 2011-06-28, 20:30   #2
KingKurly's Avatar
Sep 2010
Annapolis, MD, USA

2758 Posts

Originally Posted by apsen View Post
I had some ridiculously long job started in Prime95 and after joining PrimeNet it went and registered it there. Is there a way to report completed curves without whole job finishing so I could cancel it without just throwing it away?
Go into worktodo.txt and set the number of curves from its current number (that you think is too big) to one that is one greater than the number of completed curves. Then it'll wrap up one more curve and submit the results.

...You may want to wait until someone else confirms my answer before doing this, if you care a lot about the credits involved. But I believe my answer to be correct. I have accepted manual assignments from the server and they always list 150 curves. I have had no problems adjusting that number as low as 1.
KingKurly is offline   Reply With Quote