What exponents correspond to FFT length changes
 

I know this question has been asked may times before, but for a while now I have been trying and can't find the answer. I want to know exactly when Prime95 switches from one FFT length to another, so that I can rearrange things in my worktodo.ini file.

Does anyone know the answer off hand, or maybe have a link to the old thread?

[url]http://www.mersenne.org/status.htm[/url]

But I don't about exponents larger than 79.3 million.

I don't know about the lower ranges, but the point for switching from 1792K to 2048K FFT is about 34620000. Any exponent above that gets 2048K, and ones in the range of approximately 34560000 to 34620000 is in the "soft" crossover point, although every one of mine in that range has been tested with a 1792K FFT.

[quote=jinydu;91213][URL]http://www.mersenne.org/status.htm[/URL]

But I don't about exponents larger than 79.3 million.[/quote]
Is that table accurate? I posted because I wanted an exact answer so that I can do some rearranging of my worktodo.ini file, but could have sworn I saw somewhere that the point they switched from 1792K to 2048K was APPROXIMATELY where PhilF said.

Can we get yet another opinion on this question?

[URL="http://www.mersenneforum.org/showthread.php?t=1598"]This thread[/URL] has a post by garo quoting George comparing FFT crossovers in version 21 & 22.8, which I [I]think [/I]was the last major change to FFT crossovers.

[quote=markr;91235][URL="http://www.mersenneforum.org/showthread.php?t=1598"]This thread[/URL] has a post by garo quoting George comparing FFT crossovers in version 21 & 22.8, which I [I]think [/I]was the last major change to FFT crossovers.[/quote]
Sweet. Thanks.

dominicanpapi82,

For the "official" correspondences of exponent and FFT length, look in Prime95 source module mult.asm at tables jmptable, jmptablep, xjmptable, and xjmptablep.