@pakaran: I am about to turn machines back toward the PRPs. At this point there is not an overwhelming number of PRPs below 3300 dd.

I will work on numbers 3000 dd and above unless I see 2999 and below reaching a couple thousand. If that happens, I'll watch for a while and then possibly move my lower bound down a bit if the growth continues, or if you request help in that area.

The region below 3000 dd has surpassed 2000 entries. If it's still growing by tomorrow, I'll move my lower bound down to 1500 dd and try to clear that area out again.

(Unless, of course, someone requests me not to...)

[QUOTE=EdH;457886]The region below 3000 dd has surpassed 2000 entries. If it's still growing by tomorrow, I'll move my lower bound down to 1500 dd and try to clear that area out again...[/QUOTE]
The region is still growing, so I've moved down to 1500 dd...

There are now over 2000 entries below 996 dd. If I haven't heard anything against me working them by noon tomorrow (Monday) USA Eastern time, I will move my lower bounds to 996.

Since I have still heard no info against my bold downward trend and there is still an increasing influx of new PRPs at the lower end, I'll once again move my machines to work even lower. This time I'll move down to 994 dd, since it still leaves over 2000 below that mark.

I see pakaran has submitted a good sized group of certificates and the region below 2000 dd is only a little over 2000 entries, so I'm moving my lower bound back up to 2000 dd for now...

[QUOTE=EdH;458207]I see pakaran has submitted a good sized group of certificates and the region below 2000 dd is only a little over 2000 entries, so I'm moving my lower bound back up to 2000 dd for now...[/QUOTE]
Hmm, I seem to have miscued one of my machines and it ran a bunch of 1xxx before I caught it. Sorry if I bumped anyone. I'm (I think) back above 2000 for now with all of the machines.

@pakaran: I'm not sure where you're working and haven't seen anything being turned in recently.

Since we've got almost 3000 PRPs below 1000 dd, I'm looking at lowering my lower bound again. I'll wait until tomorrow noon to see if there is any dissent, and then, if I read none, I'll move down to 1000, followed by a further lowering, if the numbers warrant it.

Go for it. I went inactive for awhile. I've just started a run on the lowest 1000 numbers, but those will be no higher than 992 DD, just eyeballing. I'll post if I get near moving beyond that point.

[QUOTE=pakaran;458464]Go for it. I went inactive for awhile. I've just started a run on the lowest 1000 numbers, but those will be no higher than 992 DD, just eyeballing. I'll post if I get near moving beyond that point.[/QUOTE]
OK, I'll move my low end to [strike]1000[/strike] dd tonight and then take another look after I get those knocked down a bit.

Thanks for your update. (Welcome back!)

Edit: After looking over the bulk of PRPs, I decided to go ahead and aim a bit lower since you said you were within the 992 dd area at your top end. I'll drop down to 995. That leaves a few hundred between your top and my lower bounds.

Anyone with a suggestion?:
[code]
[Candidate 1]
Input=primo_[URL="http://www.factordb.com/index.php?id=1100000000294457850"]1100000000294457850[/URL].in
...
Status=Failed, impossible to certify the candidate
[/code]Just in case, I ran all the bases which resulted in no change from PRP.

I didn't try the UGS=1 that worked for the error code, since this isn't the same form of message. Should I?

Thanks for any thoughts...